ddddd
- Do I need a special valve cartridge in order to use the Bevel Gear Actuator?
- Is my equipment compatible with the HSF 250 line stop fitting?
- What if the bore of my temporary gate valve is not 8.5″ or 12.5″?
- Contact your Hydra-Stop inside sales representative or regional sales manager for additional information.
- What is tapping?
- What pipe sizes can the Hydra-Tapper tap?
- How do I order a Hydra-Core?
- Do I need to purchase ALL of the cutters?
- Will my saw mandrel work with the Hydra-Core?
- Why should I use the Bevel Gear Actuator?
- What sizes are available for the Bevel Gear Actuator?
- Do I need a special Insta-Valve 250 valve body in order to use the Bevel Gear Actuator?
- Why did Hydra-Stop change the completion plug?
- Can I use the standard Insta-Valve 250 installation equipment?
- What is turn ratio on the Bevel Gear Actuator?
- Is a coring kit required for installation?
- Is blocking required during installation?
- What is required to pressure test the valve in the horizontal position?
- Where can I find specifications for Hydra-Stop line stop fittings?
- What applications call for line stopping?
- What are the different methods of line stopping?
- How do I order a Hydra-Q.I.K.?
- What are the available nominal sizes of the HSF 250 line stop fitting?
- What is the recommended excavation size for installing the Insta-Valve Plus 250?
- How long does installation take?
- How does the Insta-Valve 250 seal?
- Does the Insta-Valve 250 install easily?
- How many excavations are required to install an Insta-Valve 250?
- Does the Insta-Valve 250 work with all common types of pipe?
- Can the Insta-Valve 250 be installed off-center?
- What sizes are available?
- Is the Insta-Valve 20-24 a permanent valve?
- What sizes are available for the Insta-Valve 20-24?
- What is the pressure rating for the Insta-Valve 20-24?
- On what types of pipe can the Insta-Valve 20-24 be installed?
- Can the Insta-Valve 20-24 be installed vertically and horizontally?
- Is the Insta-Valve 250 a permanent valve?
- How does the Insta-Valve 20-24 seal?
- What is the OD range for the Insta-Valve 20-24?
- What is the ID range for the Insta-Valve 20-24?
- Is the tapping machine powered by an air or hydraulic drive?
- In what sizes is the Insta-Valve Plus 250 available?
- How does the Insta-Valve Plus 250 seal?
- Is the Insta-Valve Plus 250 simple to install?
- Can the Insta-Valve Plus 250 gate be replaced?
- Does the Insta-Valve Plus 250 work on all common types of pipe?
- Why did Hydra-Stop change the design of the Hydra-Stop Fitting?